RenoBat

Articles

Charger Power Sources
20/05/2013
When specifying a charger it is also necessary to specify the source from which the charger derives its power, its availability and its voltage and power range.

Charger Types
23/04/2013

Chargers normally incorporate some form of voltage regulation to control the charging voltage applied to the battery.

Why do we need a UPS?
21/02/2013
     With lamp power is not stable and generates a number of problems which are described below:

Selection of UPS
07/01/2013

There are three technologies in Uninterruptible Power Supplies:

The uninterruptible power supply, UPS.
20/12/2012

It is a device with its batteries or other energy storage elements,

Stationary batteries TOPzS
11/12/2012

Batteries are a necessary integration TOPzS an increasingly competitive market.

Voltage Sensing
20/11/2012
During charging, for simplicity, the battery voltage is usually measured across the charger leads.

Charge Control Methods
25/10/2012
Many different charging and termination schemes have been developed for different chemistries and different applications. The most common ones are summarised below.

05/10/2012
The following chart summarises the charge termination methods for popular batteries. These are explained in the section below.

Charging Rates
20/09/2012
Batteries can be charged at different rates depending on the requirement. 

Typical rates are shown below:
Slow Charge = Overnight or 14-16 hours charging at 0.1C rate
Quick Charge = 3 to 6 Hours charging at 0.3C rate
Fast Charge = Less than 1 hour charging at 1.0C rate

Charge Efficiency
06/09/2012

This refers to the properties of the battery itself and does not depend on the charger.

Battery Chargers and Charging Methods
28/08/2012
More batteries are damaged by bad charging techniques than all other causes combined.

Improving Battery Life
22/08/2012
The simplest and most obvious way of getting the maximum life out of a battery is to ensure that it always works well within its designed operating limits. There are however some further actions which can be taken to increase the battery life.

Interactions Between Cells
06/08/2012

This can occur in multi-cell batteries and is a consequence of the spread of operating characteristics of the individual cells in the pack.

Manufacturing Tolerances
23/07/2012
Battery life is also affected by variations in the materials and components used in manufacturing the cells and although manufacturers try to keep these variations to a minimum there will always be a spread in the properties of the materials used within the tolerances allowed.

Cell Ageing
18/07/2012
Cell formation is the process of transforming the active materials of a new cell into their usable form. 

Chemical Changes
06/07/2012
Batteries are electrochemical devices which convert chemical energy into electrical energy or vice versa by means of controlled chemical reactions between a set of active chemicals.

Calendar Life and Cycle Life
26/06/2012
Battery performance deteriorates over time whether the battery is used or not. This is known as "calendar fade". Performance allso deteriorates with usage and this is known as "cycle fade"

Future of battery optimization maintenance
22/06/2012

Optimization is the action and effect of optimization, ie finding the best way to perform an activity.
Overall, the optimization can be performed in different areas, always with the same goal: to improve the functioning of something through improved management of resources.

Causes of sulfation in industrial batteries and utilized technology in order to desulfate.
29/05/2012

Our system of desulfation (optimization and regeneration) focuses on battery lead acid batteries (since the other batteries are sulfated) which contain as an electrolyte solution of sulfuric acid and water demineralized (distilled)


Temperature Effects
15/05/2012
The hotter the battery, the faster chemical reactions will occur. High temperatures can thus provide increased performance, but at the same time the rate of the unwanted chemical reactions will increase resulting in a corresponding loss of battery life.

Battery maintenance
08/05/2012

The conservation of battery systems operating under optimal conditions is subject to compliance with the provisions dictated by the rules of operation and maintenance.


electrolit
03/05/2012

Stepts in order to start up a car with another battery (III)
12/04/2012

After placing the clamps and finished the jumper between the two batteries isrecommended to recheck the connections to make sure NO REVERSE THEPOLARITY of the cables.


Steps in order to start up a car with another battery (II)
29/03/2012
In this article you can follow the steps to starting a car with another car's battery.

Steps in order to start up a car with another battery
13/03/2012
If you want to start a car with another car battery is necessary to follow up this steps:

How to start a car with an external battery
14/02/2012
Starting a car if you run out of battery is as easy as interconnect or establish an electrical bridge between a charged battery and a discharged and summarized to a simple electrical connection between the two batteries in parallel.

Precautions to take when we manipulate lead-acid batteries
25/01/2012

Establish an electrical bridge between two batteries is an easy operation to perform and not be converted into a dangerous task. However, the fact remains that you can take unnecessary risks to the personal integrity if you do not take some precautions listed below.


bateries
10/01/2012

Using the voltmeter to connect the charging status of batteries.
28/12/2011
Another way to find the electric charge of a lead-acid battery is to measure voltage or voltage (potential difference) between its two terminals using a voltmeter suitable for this role, although this measurement is less precise or accurate than that provided by a densimeter. 

Aspects to consider for proper operation of the battery.
28/11/2011

The key aspects to ensure that the battery provides a good service in the carare summarized in the following three points: loading, unloading andelectrolyte status.


How to clean and remove accumulated corrosion on battery terminals.
07/11/2011

A bad battery subjection to the frame of the car can cause cracks in its case due to the constant vibrations from the engine receives and cause leakage of sulfuric acid to the outside. In this article we advise you to do to prevent the cracks and how to clean accumulated sulphate battery on the outside.


Refill the low level of electrolyte
19/10/2011

The low level of electrolyte in the vessels or cells prevents the normal battery can be recharged with the load current that supplies the car's alternator or, instead, an external charger. Also, move the car with a battery that has a low electrolyte levelrise anticipated deterioration of the lead plates, which is avoided by maintaining at all times completely immersed in that solution


How to remove sulfate from the battery terminals
22/09/2011

To remove sulfate from the battery terminals and connection terminals of the cables connected to these terminals (which are responsible for distributing electricity to all consumers of current car), it is advisable to do the following:


How to change car battery?
19/09/2011
Usually when we find that the car does not start and we know perfectly well that is the battery, we to the mechanic because they change it. You are no longer have to do so because Renobat teaches you how to change it easily. Develop your questions and comments the Renobat is going resolve so you can save money by changing the battery!

Main failure on battery maintenance
30/08/2011
Some of the biggest mistakes for which the batteries often fail are bad connections. However, there came other major factors such as battery sulfation or not refill cells with distilled water.

How Rolls batteries are manufactured?
19/08/2011
Rolls Deep Cycle Batteries are used in marine applications, renewable energy, trains and they offer maximum quality. The following explanatory video will follow you throughout all the steps of manufacturing these batteries.

Main types of batteries on the market
13/07/2011
A battery is nothing more than a component that stores electricity to provide it when required. These components have experienced a great evolution from the 90s thanks to their use in mobile and portable computing. This trend will continue unstoppable, probably due to the transportation industry, primarily the automobile.

Battery Classification according to the maintenance
22/06/2011
We classify the second batteries that require maintenance and their amperage. Batteries need maintenance sulfates tend to be more, so eventually they will need a desulfation treatment.

It is worth investing in buying a good battery?
09/06/2011
Experts advise on engine, regardless of the model we choose, choose batteries providing a minimum of two years warranty, consider the reserves that have a boot than 300 amperes and a good protection that prevents the leakage of acid (a substance contained inside), to prevent corrosion of the engine.

Getting the most out of your battery
24/05/2011
This paper discusses basic point of view what we consider to maximize battery performance for various conditions and thus a cost savings. So if you take into account some of this point you will realize it in your pocket. Start you own potentials business with RenoBat.

Fed up of paying money to change the car battery? We teach you how to do it!
16/05/2011
Here we explain everything you need to know to successfully change the battery in your car. Choose from the battery to the exact procedure to change it yourself. In RenoBat committed by DIY (Do It Yourself) and thus saving costs.

Temperature effects on lead acid batteries
06/03/2011

Lead-acid batteries are designed to operate at 20-25 ° C. The low temperatures impair the behavior of the battery, reducing its effective capacity, but high for long periods drastically reduce their useful life.


Battery desulfation or regeneration
22/01/2011

For many years devices we have been used pulses, additives, special chargers in order to recover batteries, even thought all battery industry has declined. The scientific evidence to prove the improvement of the battery always invalidated these systems.


Safety when handling lead acid battery
14/11/2010
As lead-acid batteries are made from chemicals, byproducts of chemical reactions, as well as electric currents circulating in them, can produce danger to persons operating with them, maintenance and / or charge the batteries if a not proper safety procedure its followed.

Importance of maintaining the batteries
21/10/2010
Many times we do not give the importance it deserves a good battery maintenance program (consisting of an analysis followed by a battery desulfation). This we can save many headaches if a person skilled in the field we detect a failure before it occurs and what can be corrected. Thus not have to make repairs, or they will be less expensive, and we can foresee our investments.

Battery Operation
21/10/2010
Without going into technical details, how batteries work? What happens when we load or unload a battery? What effects result with these charges? What happens to most lead acid batteries?

Introduction to Batteries
21/10/2010
Batteries today are almost indispensable as a lamb that we use in many applications. Each battery type has a type of construction according to the material properties that are made. However they all have the same principle and that transform chemical energy into electrical energy. An example of lead acid batteries is that the when we charge it desulfate while when we charge them it sulfates and this creates or absorbs energy.  

What battery impedance and why it is important?
28/09/2010
Here you will find why is important to reduce the impedance to increase battery performance and thus increasing battery capacity prolonging its life.

Maintenance optimization of industrial batteries
02/09/2010
The main objective of battery maintenance optimization or regeneration is to select the most appropriate technique for each device within a system to make financial savings.
Skip Navigation LinksRenoBat - Experts en Bateries > Communication > Articles